Spindle Wire Wheel Brush — Drill Mounted, 6mm Shank, 50/75mm

Spindle-mounted wire wheel brush on a 6mm shank, for cleaning, deburring and light rust and paint removal in a drill or die grinder. The flat wheel of crimped brass-dipped wire works on its edge to get into flat areas, along lines and into recesses — the general-purpose brush for detail cleaning where a full-size angle grinder brush is too big.

Drill mounted, not an angle grinder brush
This runs on a 6mm shank in a drill or die grinder chuck, rated to a maximum of 4,500 RPM — not a threaded angle grinder brush. If you need a brush for an angle grinder, see our cup brushes and wheel brushes.

Crimped, for general cleaning
Crimped wire is the flexible, general-purpose fill — it cleans, deburrs and prepares without the aggression of a twist-knot brush. For heavier stripping, see our twist-knot spindle brush.

Wheel shape
This is the flat wheel (disc) brush, for edges and flat surfaces. For a forward-facing brush that works into corners and cupped areas, see our spindle cup brush.

Size
50mm or 75mm diameter — choose above

Brand
Abracs

Wire
Brass-dipped crimped steel

Shank
6mm

Maximum speed
4,500 RPM

Materials
Metal, and general rust, paint and residue cleaning

Uses
Detail cleaning, deburring, removing light rust and flaking paint, and surface preparation in tight or delicate areas.

Fits
Any drill or die grinder taking a 6mm shank. Never exceed 4,500 RPM — this is a low-speed brush, do not run it at angle grinder speeds.

Also known as spindle wire wheel, drill wire brush, wheel brush on shaft, mounted wire wheel or 6mm shank wire brush.