180pc Assorted Cable Tie Bases & Cradles Box - Black & White, 4 Sizes

180pc Assorted Box of Cable Tie Bases & Cradles - 180 cable tie mounts in four sizes, ninety black and ninety white, each with self adhesive backing and a screw hole.

A cable tie on its own holds a bundle together but does not hold it anywhere. A base gives the tie something to anchor to, so a run can be fixed to a flat panel, a bulkhead or the underside of a desk at whatever spacing the job needs. Every mount here takes both fixings: stick it down where the surface is clean and sound, or put a screw through it where the job has to be permanent or the panel is dusty, oily or cold. Black and white in equal measure covers both the engine bay and the office.

Box contents (180 pieces total)
Bases - flat mount, tie threads through the slot
25 x 19mm square, black
25 x 19mm square, white
20 x 27mm square, black
20 x 27mm square, white

Cradles - saddle mount, cable sits in the cradle
25 x 5mm, black
25 x 5mm, white
20 x 9mm, black
20 x 9mm, white

Sizes
Bases 19mm and 27mm square, measured across the mount. Cradles 5mm and 9mm, measured by the cable they hold

Please note
Adhesive is only as good as the surface under it - wipe clean and dry, work at room temperature, and press each mount home for a few seconds. Where the panel is dusty, oily, cold or textured, or the run will be pulled on, use the screw hole rather than relying on the tape. Black nylon stands up to sunlight better than white, so black is the better choice for engine bays, exterior and anywhere in daylight.

Suitable for
Wiring loom and harness routing, vehicle and van conversions, panel and cabinet wiring, desk, office and AV cable management, alarm and data installations, workshop and machinery cable runs

Also known as cable tie bases, cable tie mounts, tie mount bases, adhesive cable tie pads, cable tie cradles, saddle mounts, or a cable tie base assortment box.